EnGenius Network ECB600 Wireless N 300M+300M Dual Band 802.11 Access Point
Hardware
RF: 2.4 and 5 GHz Frequency Bands
Standard: IEEE 802.11a/b/g/n
Radio I: 11b/g/n: 2.4122.484 GHz
Radio II: 11a/n: 5.18-5.24 and 5.26-5.32 and 5.5-5.7 and 5.745-5.825 GHz
Data Rate: Up to 300 Mbps in both frequency bands
Memory: 64MB
Flash Memory: 8MB
Antenna
Four (4) External 5 dBi Omni-Directional Antennas
Physical Interface
1 x RJ-45 Gigabit Ethernet (10/100/1000 Mbps)
1 x Reset Button
Power Jack
Power Requirements
Power Supply: 90 to 240 VDC +/- 10%, 50/60 Hz
(depends on different countries)
Active Ethernet (Power-over-Ethernet, IEEE 802.3at/af)
Power Adapter (United States) 48VDC/0.375A
Device: 12V/2A
Modulations
OFDM: BPSK, QPSK, 26-OAM, 64-QAM, DBPSK, DQPSK, CCK
Operating Channels
2.4 GHz: US/Canada 1-11
5 GHz: Country dependent for the following ranges:
36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140, 149, 153, 157, 161, 165
Software
Topology
Infrastructure/Ad-Hoc
Operation Modes
Access Point, WDS Bridge, WDS Access Point, Universal Repeater
Multiple BSSID
Supports up to 8 BSSIDs per radio
LAN
IP (check validity and DHCP server IP range) MAC
SSID-to-VLAN Tagging
Supports 802.1q SSID-to-VLAN tagging
Spanning Tree
Supports 802.1d Spanning Tree Protocol
Wireless
Wireless Mode: 11a/11b/11g/11n
Channel selection (settings vary by country)
Channel bandwidth (Auto, 20 MHz, 40 MHz)
Transmission rate:
2.4 GHz: 11n only, 11b/b/n mix, 11b only, 11b/g, 11g only
5 GHz: 11n only, 11a/n mix, 11a only
QoS
WMM (Wireless Multimedia)
VPN
Pass-through (PPTP, L2TP, IPSec)
WPS
Software only
Management
Tx Power Control:
Adjust transmit power by dBm
Configuration:
Web-based configuration (http)/Telnet
Telnet Server:
CLI
Firmware Upgrade:
Via web browser, settings are reserved after upgrade
Administrator Setting:
Administrator Username and Password Change
Reset Setting:
Reboot (press 1 second).
Reset to factory default (press 10 seconds)
System Monitoring:
Status Statistic and Event Log
SNMP:
V1, V2c, V3
MIB:
MIB I, MIB II (RFC1213) and private MIB
Traffic Shaping:
Incoming and outgoing wireless traffic shaping
Auto-channel Selection:
Automatically selecting least congested channel
Bandwidth Measurement:
IP range and bandwidth management
Auto Reboot:
Reboot Access Point by minute, hour, day, or week
Backup and Restore:
Save and restore settings through Web interface
CLI:
Supports Command Line Interface
Diagnosis:
IP pinging statistics
Log:
SysLog and Local Log support
LED Control:
On/Off
AP Detection:
Scanning for available EnGenius Aps
Wireless / Network
PPPoE: Point-to-Point Protocol over Ethernet in Client Router mode
(this function will keep trying when failed or disconnected)
PPTP: Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
Wireless Security
WPA/WPA2 Personal (WPA-PSK using TKIP or AES)
WPA/WPA2 Enterprise (WPA-EAP using TKIP)
802.1X RADIUS Authenticator: MD5/TLS/TTLS, PEAP
SSID broadcast enable/disable
MAC Address Filtering, Up to 50 field
L2 Isolation (Access Point mode)
Wireless STA (Client) connected list (Idle/Connection Time, Pkt statistics)
QoS (Quality of Service)
WMM (Wireless Multimedia)
Item Dimension (L"xW"xH"):
12.16 x 9.17 x 3
Weight:
2.5 lb
Warranty Information:
1 Year
RF: 2.4 and 5 GHz Frequency Bands
Standard: IEEE 802.11a/b/g/n
Radio I: 11b/g/n: 2.4122.484 GHz
Radio II: 11a/n: 5.18-5.24 and 5.26-5.32 and 5.5-5.7 and 5.745-5.825 GHz
Data Rate: Up to 300 Mbps in both frequency bands
Memory: 64MB
Flash Memory: 8MB
Antenna
Four (4) External 5 dBi Omni-Directional Antennas
Physical Interface
1 x RJ-45 Gigabit Ethernet (10/100/1000 Mbps)
1 x Reset Button
Power Jack
Power Requirements
Power Supply: 90 to 240 VDC +/- 10%, 50/60 Hz
(depends on different countries)
Active Ethernet (Power-over-Ethernet, IEEE 802.3at/af)
Power Adapter (United States) 48VDC/0.375A
Device: 12V/2A
Modulations
OFDM: BPSK, QPSK, 26-OAM, 64-QAM, DBPSK, DQPSK, CCK
Operating Channels
2.4 GHz: US/Canada 1-11
5 GHz: Country dependent for the following ranges:
36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140, 149, 153, 157, 161, 165
Software
Topology
Infrastructure/Ad-Hoc
Operation Modes
Access Point, WDS Bridge, WDS Access Point, Universal Repeater
Multiple BSSID
Supports up to 8 BSSIDs per radio
LAN
IP (check validity and DHCP server IP range) MAC
SSID-to-VLAN Tagging
Supports 802.1q SSID-to-VLAN tagging
Spanning Tree
Supports 802.1d Spanning Tree Protocol
Wireless
Wireless Mode: 11a/11b/11g/11n
Channel selection (settings vary by country)
Channel bandwidth (Auto, 20 MHz, 40 MHz)
Transmission rate:
2.4 GHz: 11n only, 11b/b/n mix, 11b only, 11b/g, 11g only
5 GHz: 11n only, 11a/n mix, 11a only
QoS
WMM (Wireless Multimedia)
VPN
Pass-through (PPTP, L2TP, IPSec)
WPS
Software only
Management
Tx Power Control:
Adjust transmit power by dBm
Configuration:
Web-based configuration (http)/Telnet
Telnet Server:
CLI
Firmware Upgrade:
Via web browser, settings are reserved after upgrade
Administrator Setting:
Administrator Username and Password Change
Reset Setting:
Reboot (press 1 second).
Reset to factory default (press 10 seconds)
System Monitoring:
Status Statistic and Event Log
SNMP:
V1, V2c, V3
MIB:
MIB I, MIB II (RFC1213) and private MIB
Traffic Shaping:
Incoming and outgoing wireless traffic shaping
Auto-channel Selection:
Automatically selecting least congested channel
Bandwidth Measurement:
IP range and bandwidth management
Auto Reboot:
Reboot Access Point by minute, hour, day, or week
Backup and Restore:
Save and restore settings through Web interface
CLI:
Supports Command Line Interface
Diagnosis:
IP pinging statistics
Log:
SysLog and Local Log support
LED Control:
On/Off
AP Detection:
Scanning for available EnGenius Aps
Wireless / Network
PPPoE: Point-to-Point Protocol over Ethernet in Client Router mode
(this function will keep trying when failed or disconnected)
PPTP: Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
Wireless Security
WPA/WPA2 Personal (WPA-PSK using TKIP or AES)
WPA/WPA2 Enterprise (WPA-EAP using TKIP)
802.1X RADIUS Authenticator: MD5/TLS/TTLS, PEAP
SSID broadcast enable/disable
MAC Address Filtering, Up to 50 field
L2 Isolation (Access Point mode)
Wireless STA (Client) connected list (Idle/Connection Time, Pkt statistics)
QoS (Quality of Service)
WMM (Wireless Multimedia)
Item Dimension (L"xW"xH"):
12.16 x 9.17 x 3
Weight:
2.5 lb
Warranty Information:
1 Year
